Categories


212x104, 2.13inch flexible E-Ink display HAT for Raspberry Pi

Product Code: Waveshare 15084

212x104, 2.13inch flexible E-Ink display HAT for Raspberry Pi
212x104, 2.13inch flexible E-Ink display HAT for Raspberry Pi
212x104, 2.13inch flexible E-Ink display HAT for Raspberry Pi
212x104, 2.13inch flexible E-Ink display HAT for Raspberry Pi

₹2,079.00
GST inclusive



Qty:

Availability: Backorder


Add to Wish List



212x104, 2.13inch flexible E-Ink display HAT for Raspberry Pi, black/white dual-color, SPI interface.

This is a flexible E-Ink display HAT for Raspberry Pi, 2.13inch, 212x104 resolution, with embedded controller, communicating via SPI interface, supports partial refresh.

Compared with normal e-Paper panels, this flexible panel allows bending without being damaged, and it's thinner and lighter.

Combined with the advantages like ultra low power consumption, wide viewing angle, clear display without electricity, it is an ideal choice for applications where curved surface display is required, such as industrial instruments, smart wearable-devices, and so on.

Features

  • No backlight, keeps displaying last content for a long time even when power down
  • Ultra low power consumption, basically power is only required for refreshing
  • Compatible with Raspberry Pi Zero/Zero W/Zero WH/2B/3B/3B+
  • Preserved solder pads for SPI interface, for connecting with other controller boards like Arduino/Nucleo, etc.
  • Comes with development resources and manual (examples for Raspberry Pi/Arduino/STM32)

Specifications

  • Operating voltage: 3.3V
  • Interface: 3-wire SPI, 4-wire SPI
  • Outline dimension: 59.2mm × 29.2mm × 0.3mm
  • Display size: 23.71mm × 48.55mm
  • Dot pitch: 0.229 × 0.228
  • Resolution: 212 × 104
  • Display color: black, white
  • Grey level: 2
  • Full refresh time: 2s
  • Refresh power: 26.4mW(typ.)
  • Standby power: <0.017mW
  • Viewing angle: >170°

Interface

Symbol Description
VCC 3.3V / 5V
GND Ground
NC NC
DIN SPI MOSI pin
CLK SPI SCK pin
CS SPI chip selection, low active
DC Data/Command selection (high for data, low for command)
RST External reset, low active
BUSY Busy status output, low active

Dimensions

2.13inch e-Paper HAT (D) dimensions

PACKAGE CONTENT

  1. 2.13inch e-Paper (D) x1
  2. e-Paper Driver HAT x1
  3. RPi screws pack (2pcs) x1
  4. PH2.0 20cm 8Pin x1

Development Resources

Wiki : www.waveshare.com/wiki/2.13inch_e-Paper_HAT_(D)

Write a review
Your Name:


Your Review:
Note: HTML is not translated!
Rating:
Bad           Good

Enter the code in the box below:



© 2024, MG Automation Technologies. Powered by MG Super LABS.Find us on Google+
Designed with by