OAK-D-IoT-40, OpenCV AI Machine Vision Kit, Depth Measuring, Image Recognition

Overview :
The OAK-D-IoT-40 baseboard has three on-board cameras which implement stereo and RGB vision, piped directly into the OAK-SoM-IoT for depth and AI processing. The data can be then output to a host via USB 3.1 Gen1 (Type-C) or via ESP32 WiFi interface. If you are new to OAK IOT devices, you can check Getting started with OAK IoT devices tutorial.
This design is one of two baseboards for the OAK-SoM-IoT, the other one being OAK-D-IOT-75. The only differnece is the the stereo baseline distance and the shape/size of the OAK camera.

Hardware specifications : This OAK camera uses USB-C cable for communication and power. It supports both USB2 and USB3 (5Gbps / 10Gbps).

Myriad X inside : This OAK device has on-board Myriad X VPU.

4 TOPS of processing power (1.4 TOPS for AI)
Run any AI model, even custom architectured/built ones - models need to be converted.
Encoding: H.264, H.265, MJPEG - 4K/30FPS, 1080P/60FPS
Computer vision: warp/dewarp, resize, crop via ImageManip node, edge detection, feature tracking. You can also run custom CV functions
Stereo depth perception with filtering, post-processing, RGB-depth alignment, and high configurability
Object tracking: 2D and 3D tracking with ObjectTracker node

Dimensions and Weight :

Width: 60 mm
Height: 45 mm
Length: 25 mm (including the SoM)
Weight: 45.5g (total), 20g (PCBA), 25.5g (SoM with heatsink)

Depth perception :

This OAK camera has a baseline of 4.0cm - the distance between left and right stereo camera. Minimal and maximal depth perception depends on camera FOV, resolution, and baseline 
Min perceivable distance: ~20cm (400P OR 800P, extended), ~37cm (800P)
Max perceivable distance: ~21 meters
Extended means that StereoDepth node has Extended disparity mode enabled.

Getting started : The OAK-D-IoT-40 accepts power input from 5V barrel jack and it can also accept power from USB C connector. Booting can be accomplished from either the ESP32 or NOR flash on the BW1099EMB, boot selection is configured on BW1099EMB with BOOT resistors.

The reset button resets the OAK-SoM-IoT only.
The 5V LED indicates 5V power is present on the DM1092.
The PG LED indicates “power good” from the OAK-SoM-IoT.
The “RUN” LED indicates that the OAK-SoM-IoT is not reset.